вот мой dmesg без установленных драйверов....
====================================
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
* * * *The Regents of the University of California. All rights reserved.
FreeBSD 5.1-RELEASE #0: Sun Mar 28 20:55:52 MSD 2004
* *root@:/usr/src/sys/i386/compile/NEW_KERNEL
Preloaded elf kernel "/boot/kernel/kernel" at 0xc06f8000.
Preloaded elf module "/boot/kernel/snd_emu10k1.ko" at 0xc06f8244.
Preloaded elf module "/boot/kernel/snd_pcm.ko" at 0xc06f82f4.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc06f83a0.
Timecounter "i8254" *frequency 1193182 Hz
Timecounter "TSC" *frequency 1837512124 Hz
CPU: AMD Athlon(tm) XP 2500+ (1837.51-MHz 686-class CPU)
*Origin = "AuthenticAMD" *Id = 0x6a0 *Stepping = 0
*Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CM
OV,PAT,PSE36,MMX,FXSR,SSE>
*AMD Features=0xc0400000<AMIE,DSP,3DNow!>
real memory *= 536805376 (511 MB)
avail memory = 513863680 (490 MB)
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <Nvidia AWRDACPI> on motherboard
pcibios: BIOS version 2.10
Using $PIR table, 13 entries at 0xc00fde90
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-fast" *frequency 3579545 Hz
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0
acpi_cpu0: <CPU> on acpi0
acpi_tz0: <thermal zone> on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pci0: <memory, RAM> at device 0.1 (no driver attached)
pci0: <memory, RAM> at device 0.2 (no driver attached)
pci0: <memory, RAM> at device 0.3 (no driver attached)
pci0: <memory, RAM> at device 0.4 (no driver attached)
pci0: <memory, RAM> at device 0.5 (no driver attached)
isab0: <PCI-ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
pci0: <serial bus, SMBus> at device 1.1 (no driver attached)
ohci0: <OHCI (generic) USB controller> mem 0xe7001000-0xe7001fff irq 11 at devic
e 2.0 on pci0
usb0: OHCI version 1.0, legacy support
usb0: <OHCI (generic) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: (0x10de) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
ohci1: <OHCI (generic) USB controller> mem 0xe7002000-0xe7002fff irq 5 at device
2.1 on pci0
usb1: OHCI version 1.0, legacy support
usb1: <OHCI (generic) USB controller> on ohci1
usb1: USB revision 1.0
uhub1: (0x10de) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 3 ports with 3 removable, self powered
pci0: <serial bus, USB> at device 2.2 (no driver attached)
pcib1: <ACPI PCI-PCI bridge> at device 8.0 on pci0
pci1: <ACPI PCI bus> on pcib1
pcm0: <Creative EMU10K1> port 0xc000-0xc01f irq 5 at device 9.0 on pci1
pcm0: <eMicro EM28028 AC97 Codec>
rl0: <RealTek 8139 10/100BaseTX> port 0xc800-0xc8ff mem 0xe6081000-0xe60810ff ir
q 11 at device 11.0 on pci1
rl0: Realtek 8139B detected. Warning, this may be unstable in autoselect mode
rl0: Ethernet address: 00:04:61:4b:54:c9
miibus0: <MII bus> on rl0
rlphy0: <RealTek internal media interface> on miibus0
rlphy0: *10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fwohci0: <Lucent FW322/323> mem 0xe6082000-0xe6082fff irq 5 at device 13.0 on pc
i1
fwohci0: OHCI version 1.0 (ROM=1)
fwohci0: No. of Isochronous channel is 8.
fwohci0: EUI64 00:04:61:00:00:04:5c:44
fwohci0: Phy 1394a available S400, 3 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
if_fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:04:61:04:5c:44
sbp0: <SBP2/SCSI over firewire> on firewire0
fwohci0: Initiate bus reset
atapci0: <nVidia nForce2 UDMA133 controller> port 0xf000-0xf00f at device 9.0 on
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
pci2: <display, VGA> at device 0.0 (no driver attached)
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port 0x3f7,0x3f0-0
x3f5 irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
sio1 port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
ppc0 port 0x778-0x77b,0x378-0x37f irq 7 on acpi0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse Explorer, device ID 4
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 10.000 msec
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
acpi_cpu: throttling enabled, 2 steps (100% to 50.0%), currently 100.0%
ad0: 57277MB <SAMSUNG SP6003H> [116374/16/63] at ata0-master UDMA100
acd0: CDROM <NEC CD-ROM DRIVE:282> at ata1-slave PIO4
Mounting root from ufs:/dev/ad0s2a
