[решено] создание точки восстановления через командную строку

Vadikan · Конфигурация компьютера

Sparkster
Так просто в лоб не получится, но решения есть. Например, FileForum | System Restore Point Creator или VBS сценарий.

Код:

'Unattended System Restore Point 
'sysrestorepoint.vbs 
'© Doug Knox - rev 02/11/2002 
'This code may be freely distributed/modified 
'Downloaded from www.dougknox.com 
'Extracted from original code by Bill James - www.billsway.com 

Set sr = getobject("winmgmts:\\.\root\default:Systemrestore") 

msg = "New Restore Point successfully created." & vbCR 
msg = msg & "It is listed as: " & vbCR 
msg = msg & "Automatic Restore Point " & Date & " " & Time 

'Put a ' in front of the next five lines to disable the Success Failed Prompt. 
If (sr.createrestorepoint("Automatic Restore Point", 0, 100)) = 0 Then 
    MsgBox msg 
Else 
    MsgBox "Restore Point creation Failed!" 
End If 

'Remove the ' from these lines to only alert you if the process failed 
'If (sr.createrestorepoint("Automatic Restore Point", 0, 100)) = 0 Then 
'    MsgBox "Restore Point creation Failed!" 
'End If 

Set sr = Nothing

Сохраните с расширением VBS.