[NonO123]

SMART

TFormSMART.SetDisk: disk.name=DISK01 (SAMSUNG HD103SJ) ; devicePath=\\.\PHYSICALDRIVE1\; disk.ParentBaseBlock=0
TWinSMART > physDriveNo=1
TWinSMART > SMART successfully enabled on physical drive: 1
TWinSMART > DFP_GET_VERSION returned:
TWinSMART > Version = 1
TWinSMART > Revision = 1
TWinSMART > Capabilities = 0x00000007
TWinSMART > Reserved = 0x0
TWinSMART > IDEDeviceMap = 0x1
TWinSMART > Drive 1 is an IDE Hard drive that supports SMART
TWinSMART > #Cylinders: 16383, #Heads: 16, #Sectors per Track: 63
TWinSMART > Model number: SAMSUNG HD103SJ
TWinSMART > Firmware rev: 1AJ10001
TWinSMART > Serial number: S246J9CB204833
TWinSMART > ATA identify cmd, bytesReturned=528
TWinSMART > GetSMARTData - entered. DriveNo=1
SMART information for drive "SAMSUNG HD103SJ"
Attribute Structure Revision: 16 Threshold Structure Revision: 16
Attribute Structure Length: 512 Threshold Structure Length: 512

Note: Attributes with a red background are potential indicators of imminent electromechanical failure. If their treshold value is underrun, your drive health is at risk.
Typically the current- and treshold values are normalized to 100%. 100 = very good, 0 = total failure.
However the normalization can be also 254=very good. All values are vendor specific and are subject to change.
The worst value indicates show worst value of the attribute ever occured.
If the current value falls under the treshold value the table shows 'bad' status, else 'good' status
The raw value is vendor specific and must be re-calculated via formula to get a human readable value.
0x01/ 1 Raw Read Error Rate 100 100 51 Good 371
0x02/ 2 Throughput Performance 252 252 0 Good 0
0x03/ 3 Spin Up Time 71 69 25 Good 8936
0x04/ 4 Start/Stop Count 99 99 0 Good 1936
0x05/ 5 Reallocated Sector Count 252 252 10 Good 0
0x07/ 7 Seek Error Rate 252 252 51 Good 0
0x08/ 8 Seek Time Performance 252 252 15 Good 0
0x09/ 9 Power On Hours Count 100 100 0 Good 7748
0x0A/ 10 Spin Retry Count 252 252 51 Good 0
0x0B/ 11 Calibration Retry Count 252 252 0 Good 0
0x0C/ 12 Power Cycle Count 99 99 0 Good 1944
0xBF/191 G-sense error rate 100 100 0 Good 51
0xC0/192 Power-off Retract Count/Emergency Retract Cycle count 252 252 0 Good 0
0xC2/194 Temperature 64 50 0 Good 917562
0xC3/195 Reported Uncorrectable Errors 100 100 0 Good 0
0xC4/196 Reallocation Event Count 252 252 0 Good 0
0xC5/197 Current Pending Sector Count 252 100 0 Good 0
0xC6/198 Uncorrectable Sector Count 252 252 0 Good 0
0xC7/199 UltraDMA CRC Error Count 100 100 0 Good 1
0xC8/200 Multi-Zone Error Rate/Write Error Rate 100 100 0 Good 77
0xDF/223 Load/Unload Retry Count 252 252 0 Good 0
0xE1/225 Load/Unload Cycle Count 100 100 0 Good 1964