Проблема решена.
Опишу мои действия.
С сайта
http://www.siliconimage.com/support/...ctid=2&osid=1& скачал драйвер:
http://www.siliconimage.com/docs/SWD...10LR5-1058.zip
Далее по инструкции:
2. FRESH INSTALLATION TO A BOOT DRIVE
Installing the SiI Driver currently requires some manual intervention. It also requires to disable probing so that the Open Source Drivers does not get installed. At boot time type:
'linux noprobe' at the boot prompt.
When you get to the screen shown in figure 1, get a shell prompt (see last page) and execute the initial_install script as followings to install the driver for boot disk:
# mkdir /f
# mount /dev/fd0 /f
# cd /f
# ./initial_install.sh
Figure 1:
| Warning |
No hard drives have been found.
You probably need to manually
choose device drivers for the
for the installation to succeed. Would
you like to select drivers now?
| Yes | | No |
Once the driver is installed select 'No' and then 'Done' on the next two screens. Continue with the installation.
At the end, go to shell prompt ([Ctrl]-[Alt]-[F2]) to run the script below BEFORE REBOOTING.
./upgrade_driver.sh
This last step writes all the drivers permanently into the kernel.
Go back to the last screen (such as [Ctrl]-[Alt]-[F7]) to reboot the system. Installation of boot disk at this point is completed.
Установка Red Hat Enterprise Linux 4.0 завершена успешно.
Спасибо всем откликнувшимся.
